Ultrastretch one-piece neoprene at the neck, easier to get over the shoulders.
Drainage holes at the bottom of the rear flap and in the key pocket.
Recycled polyester lining.
Sheico N ultra-stretch neoprene foam, Xtend ultrastretch lamination. The components used are the most elastic on the market.
"Power seam" seamless method, interior tape and silicone outer seal to ensure elasticity and a watertight seal, water cannot seep through the seams.
Seal cuffs where the suit meets the skin. toggle to adjust the closure of the zip flap. Key pocket
Without any rough edges to enable the best possible seal at the water inlets. However, water can seep in if you fall off or if you have chosen the wrong size.
The top of the wetsuit is assembled in a single piece from arm to arm for the best possible elasticity when putting it over your shoulders whilst retaining a tight seal when the wetsuit is done up. Large stainless steel zipper for easy grip.
The combination of Neoprene and a seamless assembly preventing the entry of water makes this 4/3 mm a very warm wetsuit.
Cuffs where the suit meets the skin.
These keep water out, preventing capillary and geyser action during wind sports.
on the right calf, with a cord and gusset flap.
ML and LXL are the same width as the M or the L, but 10 cm longer (5 on the chest, 5 on the legs)
Adjustable elastics on front flap.
The cut of this wetsuit normally makes for a perfect fit thanks to numerous fittings and tests. However, for some body types, you may need to adjust the front strip using the 2 elastics provided.
Front zip fastening.
Symmetrical to allow shoulders to rotate symmetrically. Large stainless steel PK zip for easy zipping. Elastics for easy tightening to adjust seals.
Assembled by hand by our supplier partner SHEICO's Neoprene experts.